Application
- Friction wear rate test for new material
- Evaluation of various lubricants
- Evaluation of paper, film and plastic
- Friction, abrasion, and scratch testing of various coating films
Specification
| Model | TYPE: 40 | ||||||
| Moving speed | 5mm～6000mm／min | ||||||
| Drive motor | AC servo motor | ||||||
| Drive system | Rack-and-pinion | ||||||
| Moving distance | 1～100mm | ||||||
| Move mode | Single mode: Automatic stop after moving the set distance Repeat mode: Reciprocating motion over the set distance (up to 99,999,999 times) |
||||||
| Measurement Range | 0～1000gf | ||||||
| Table dimensions | 240mm×120mm | ||||||
| Safety device | 240mm×120mm | ||||||
| Dynamic distortion amplifier | Zero point adjustment: Manual / auto zero ± 0.5 mV / V or less Output (non-linearity): 0 to ± 5V (within ± 0.01% FS) Zero point drift ･ ･ ･ 0.01% FS / ℃ Gain drift ･ ･ ･ 0.01% FS / ℃ Low-pass filter: Approximately 500Hz |
||||||
| Power supply | AC100V 50／60Hz | ||||||
| Dimensions | W475mm x D450mm x H475mm * Excluding protrusions | ||||||
| Accessories | 1 load transducer, 1 scratch needle, 1 set of Φ10 mm ball indenter, 1 set of ASTM flat indenters, 1 power cord (2 m with 2P / E), 1 parts case, 1 set of tools, 1 copy of instruction manual |
||||||
